Fibre Cement Fixings
Fixings for corrugated fibre cement roof and wall sheets, with options for light steel, heavy steel and timber supports. The screws incorporate reaming wings to form clearance through the sheet and BAZ washer assemblies to seal around the fixing.
Fibre Cement to Light Steel
Fibre cement screws for light steel secure corrugated roof and wall sheets to steel purlins and rails. Our standard screws have a 6.3mm diameter and No. 3 drill point.
Check the actual steel thickness and grade against the selected screw’s application limits. Choose the length using its published fixing build up range and the depth at the specified fixing position.
Fibre Cement to Heavy Steel
Fibre cement screws for heavy steel secure corrugated roof and wall sheets to thicker steel supports, including suitable hot rolled sections. Our standard screws have a 6.3mm diameter and No. 5 drill point.
Confirm the support thickness and steel grade against the product’s application limits. The selected length must allow the drill point to clear the steel and the fixing thread to engage correctly.
Fibre Cement to Timber
Fibre cement screws for timber secure corrugated roof and wall sheets to timber purlins and rails. Our standard screws have a 6.3mm diameter and Type 17 gash point to assist entry into the timber.
Check the fixing depth against the published maximum fixing build up. Allow the specified full thread engagement in sound timber, excluding the point and any plain shank.
Fixing Options
Lengths & Selection
Select the screw using its published fixing build up range, including any stated minimum and maximum. The thread and reaming wings must be correctly positioned for the sheet and support.
Check the depth at the actual fixing position, allowing for the corrugation, sheet laps, packers and installed BAZ washer assembly. Follow the product data’s definition of the range and its allowances. Sheet material thickness alone does not represent this fixing depth.
Our Fixing Length and Application Ranges guide (PDF) explains fixing measurements, washer allowances and thread engagement.
Washers & Hole Clearance
The supplied BAZ washer assembly combines a formed A2 stainless steel disc with an EPDM rubber seal. It seals around the fixing on the curved sheet surface. Use the complete assembly specified for the screw and sheet profile.
Reaming wings enlarge the hole through the fibre cement to provide clearance around the screw. Check that the resulting hole meets the sheet system’s movement requirements, including any separate drilling or preparation specified for the installation.
Our Sealing Washers Explained guide (PDF) includes the BAZ assembly and guidance on correct seating.
Coatings & Corrosion
The supplied screws are manufactured from carbon steel with a protective Ruspert coating. The A2 stainless steel component is the disc within the BAZ washer assembly.
Select the complete fixing assembly for the building’s exposure conditions. Consider coastal salts, condensation and contaminants associated with agricultural or industrial use, together with compatibility with any timber preservative treatment.
Our Coatings and Corrosion Guide (PDF) explains protective finishes, exposure considerations and salt spray test results.
Installation & Sheet Compatibility
The listed BAZ washer fixings are specified for crown fixing. Follow the sheet system’s fixing layout and check any additional support requirements, particularly for wall cladding. Confirm that the hole clearance meets the requirements for the selected sheet and fixing.
Use a variable-speed screw gun with suitable depth control and the correct socket. Do not use an impact driver. Seat the complete BAZ washer assembly evenly, tightening as specified without overtightening or cracking the sheet.
Follow the sheet system’s drilling and dust control instructions. Our Fixing Selection and Installation Guide (PDF) provides further guidance on fixing selection and installation.