Hook Bolts
Hook bolts secure compatible roofing and cladding sheets to supporting steelwork. The hooked end engages with the support, while the threaded end is secured with a nut and the specified washer and sealing components.
Hook Shapes & Supports
The hook opening, bend and upturn must suit the supporting section so the bolt engages correctly and aligns with the fixing position through the sheet. Bolts of the same diameter and length can have different hook shapes.
Different supports can require different bends. Crook bolts are used with cold rolled Z purlins, while square bends can accommodate wider sections. Check the shape against the actual support dimensions rather than choosing by the sheet profile alone.
Sizes & Lengths
Bolt diameter and length are selected to suit the fixing specification. The required length must accommodate the support, sheet profile, any laps and the washer assembly, with enough usable thread for the nut to engage fully.
Check the threaded length separately from the overall bolt length. Use the product’s dimensioned drawing to confirm where measurements are taken, particularly when comparing different hook shapes or replacing an existing bolt.
Nuts, Washers & Fitting
Use a nut that matches the bolt thread, together with the washer and sealing components specified for the sheet system. Where the sealing arrangement includes a cover over the nut, fit the matching cover as part of the assembly.
Follow the sheet manufacturer’s requirements for fixing positions and drilled hole clearances. Check that the hook engages correctly before tightening, then seat the washer assembly in accordance with the installation instructions without crushing the seal, cracking the sheet or distorting its profile.